All questions shall be directed to the Construction Officer at 309-732-2906. This Project has been cleared of LBP. All work that is done must comply with LBP protocol and not disturb any of the interim or abated controls put in place from the previous completed work. Remove the existing brick chimney off the addition on the south side. Once below the roof line, cap the top with air tight noncombustible material Preventing it from ever being used. Remove existing shingles down to sheathing. Check over all the existing roof sheathing for any water damage, broken boards, and larger than 1/2 " gaps between sheathing replace as needed. If sheath over is required a change order must be okayed by the Construction Officer before continuing. Patch the existing holes from the turtle/can vents. Remove the sheathing at the ridge per shingle over vent manufactures directions. Install ice and snow guard around the lower section of roof making sure to cover at least a 2 ft over top plate on the exterior walls below. Installed approved water barrier over the remainder roof. Install 30-year architectural shingles homeowners' choice of colors. New shingle over ridge vent. New chimney flashing and counter flashing. New plumber boots over the vents and split ring for the mast flashing. New 2" white style D roof edge. Install Tyvek house wrap over all the existing wood siding over lapping 6", tape all the seams. Install 1/4 " fan fold over the house wrap taping all the seams installed with cap nails. Bend white break metal around the bottom of wall installing over the wrap and fold and returning to the foundation. Install double 4" vinyl siding choice of colors the homeowner selects from samples provide by the contractor. All wall and floor penetrations shall have either a light block or split trim installed and caulked with a color match. All top course pieces must be snap-locked into a utility trim preventing siding from blowing off. Install missing soffit and fascia mostly on the room addition. Install new white gutters and downs through out the entire house. Install 6' tail pipes off the downs with hinged flip-ups securing the tails from being blown off. Minimum 2 straps per 8' of down securing to the wall. All Connections must have at least 2 white screws per joint. Contractor must have permit before the work begins.