Reference Number 0000277805 Question Acceptance Deadline 2024/09/17 12:00:00 AM EDT Pricing Lump sum Design and Supply: Design, fabricate, and supply a fully packaged hot water heating boiler plant enclosed within a shipping container. 3.2.2. Installation: The system shall be delivered to the construction site ready for connection to piping and electrical power. 3.2.3. Commissioning: Provide commissioning services to ensure the system operates as intended. Government Services Canada (PWGSC), is pleased to invite you to bid on the work for the aforementioned Tender Package.Bidders interested in participating in this call for tenders shall be required to obtain all plans and tender documents from the Building Connected platform or the MERX Private website, subject to the applicable conditions of the site. The Drawings show the general character and scope of the Work and not the exact details of the installation. Install all equipment and systems complete with all accessories required for a complete and operational installation. 1.8.2. The location, arrangement and connection of equipment and material as shown on the Drawings represents a close approximation to the intent and requirements of the Work. The right is reserved by the Engineer's Representative to make reasonable changes required to accommodate conditions arising during the progress of the Work, at no additional cost. 1.8.3. In order to show more clearly the arrangement of the Work, plans and sections do not show every valve, thermometer, pressure gauge or other system accessory. Refer to the Mechanical Standard Details and to the Specifications to determine the requirements. 1.8.4. Install equipment in accordance with the manufacturer's written installation requirements. In the event of conflicts between the Drawings or Specifications and the manufacturer's written installation requirements, notify the Engineer's Representative for resolution. Certain Details indicated on the Drawings are general in nature and specific labelled detail references to each and every occurrence of use are not indicated, however, such details are applicable to every occurrence. 1.8.6. The location and size of existing services shown on the Drawings are based on the best available information. Site verify the actual location of existing services before commencing Work. Pay particular attention to underground services. 1.8.7. Make changes and modifications necessary to ensure co-ordination and to avoid interference and conflicts with other Trades, or to accommodate existing conditions, at no additional cost. Leave areas clear of piping and ducts where space is indicated as reserved for future 1.8.8. equipment and equipment for other Trades. Coordinate piping low point drain locations so that they are not above or adjacent to electrical equipment, including junction boxes. 1.8.9. 1.8.10. Allow adequate space and provisions for the removal of coils and servicing of equipment, with minimum inconvenience to the operation of systems. Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform.